基于电化学老化衰退模型的锂离子动力电池外特性

当前锂离子动力电池电化学模型存在模型复杂、建模难度大、计算效率低、老化评估效果差的问题,本文提出一种考虑电池衰退老化的机理模型(ADME).本文首先通过有限差分法对伪二维(P2D)电化学模型进行离散降阶处理,得到简化伪二维(SP2D)模型.在SP2D模型的基础上,基于阴阳两极发生的副反应导致的衰退老化现象,提出一种考虑电池衰退老化的机理模型.其次,使用多变量偏差补偿最小二乘法实现模型参数辨识.最后通过动力电池衰退老化性能循环实验,对比分析了恒流、脉冲工况下SP2D模型和ADME模型的终端电压输出.结果表明:ADME模型较为简单、计算效率和估算精度高,可以有效评估电池容量老化衰退,得到理想的锂离子动力电池外特性曲线.     

Effect of external electric field on the terahertz transmission characteristics of electrolyte solutions

We fabricated a microfluidic chip with simple structure and good sealing performance, and studied the influence of the electric field on THz absorption intensity of liquid samples treated at different times by using THz time domain spectroscopy system. The tested liquids were deionised water and CuSO₄, CuCl₂, NaHCO₃, Na₂CO₃ and NaCl solutions. The transmission intensity of the THz wave increases as the standing time of the electrolyte solution in the electric field increases. The applied electric field alters the dipole moment of water molecules in the electrolyte solution, which affects the vibration and rotation of the whole water molecules, breaks the hydrogen bonds in the water, increases the number of single water molecules and leads to the enhancement of the THz transmission spectrum.     

A rapid dissolution procedure to aid initial nuclear forensics investigations of chemically refractory compounds and particles prior to gamma spectrometry

A rapid and effective preparative procedure has been evaluated for the accurate determination of low-energy (40–200 keV) gamma-emitting radionuclides (²¹⁰Pb, ²³⁴Th, ²²⁶Ra, ²³⁵U) in uranium ores and uranium ore concentrates (UOCs) using high-resolution gamma ray spectrometry. The measurement of low-energy gamma photons is complicated in heterogeneous samples containing high-density mineral phases and in such situations activity concentrations will be underestimated. This is because attenuation corrections, calculated based on sample mean density, do not properly correct where dense grains are dispersed within a less dense matrix (analogous to a nugget effect). The current method overcomes these problems using a lithium tetraborate fusion that readily dissolves all components including high-density, self-attenuating minerals/compounds. This is the ideal method for dissolving complex, non-volatile components in soils, rocks, mineral concentrates, and other materials where density reduction is required. Lithium borate fusion avoids the need for theoretical efficiency corrections or measurement of matrix matched calibration standards. The resulting homogeneous quenched glass produced can be quickly dissolved in nitric acid producing low-density solutions that can be counted by gamma spectrometry. The effectiveness of the technique is demonstrated using uranium-bearing Certified Reference Materials and provides accurate activity concentration determinations compared to the underestimated activity concentrations derived from direct measurements of a bulk sample. The procedure offers an effective solution for initial nuclear forensic studies where complex refractory minerals or matrices exist. It is also significantly faster, safer and simpler than alternative approaches.     

强度解调型光纤光栅温度传感实验

光纤光栅在工程上应用广泛,但由于存在解调系统复杂、成本高,尤其是需要使用光纤光谱仪等波长解调仪器,使得光纤光栅很难走入本科教学的实验课堂.本文提出了一种基于窄线宽DFB激光器的强度解调方案,极大地简化了光纤光栅传感器的解调系统,完全满足较高分辨率和实时检测的系统要求.合理安排的温度传感实验可以非常直观地展示光纤光栅的线性传感性能,使得工程化的光纤光栅传感技术轻松走进本科教学课堂,具有极高的推广和应用潜力.     

基于连续量子级联激光器的1103.4cm–1处NH3混叠吸收光谱特性研究

由于NH3在大气气溶胶化学中具有重要作用,所以快速和精确反演NH3浓度对环境问题非常重要.本文以9.05μm的室温连续量子级联激光器(quantum cascade laser,QCL)作为光源,采用波长扫描直接吸收可调谐二极管激光吸收光谱(tunable diode laser absorption spectroscopy,TDLAS)技术,研究了QCL在1103.4 cm–1的光谱特性,获得了激光器控制的温度电流与波长的关系.设计了QCL二级温控的低压实验平台,测量氨气在1103.4 cm–1处的6条混叠吸收线,在降低压强的情况下谱线展宽变小,使混叠光谱分离,由此计算各条吸收线的线强,进一步对测量不确定度进行分析.针对混叠严重的光谱提出了低压分离单光谱精确反演气体浓度的方法,并进行了实验验证.通过与HITRAN数据库进行结果对比,得出氨气在1103.4 cm–1的实验测量线强值与数据库偏差为2.71%-4.71%,实验测量线强值的不确定度在2.42%-8.92%,极低压条件下反演浓度与实际值的偏差在1%-3%.     

EicC对撞光学设计

EicC是中国科学院近代物理研究所计划建造的中国电子-离子对撞机装置,该对撞机质心能位于20 GeV附近,是研究海夸克的最佳能量窗口,同时还可研究胶子和价夸克。EicC对撞粒子为高极化率质子和电子束团,质子环pRing采用八字环设计方案,可以更好地保持极化质子束团极化率,电子环eRing采用跑道形环设计方案,可以更好地利用隧道空间。该装置电子束流能量中心值为3.5 GeV,电子束RMS发射度为水平方向60 nm·rad,垂直方向60 nm·rad,对撞点b函数为水平方向0.4 m,垂直方向0.12 m;质子束流能量中心值20 GeV,质子束RMS发射度为水平方向300 nm·rad,垂直方向180 nm·rad,对撞点b函数为水平方向0.08 m,垂直方向0.04 m,设计亮度2×1033 cm–2s–1。EicC采用双对撞区非对称光学设计,通过对EicC不同色品补偿方案的研究,最终确定了弧区加短直线节共同补偿的色品补偿方案;通过研究对撞点处b函数以及对撞点间相移对动力学孔径的影响,最终得到pRing动力学孔径大于8 s(s为束团RMS尺寸)、eRing动力学孔径大于20 s,满足大于束团尺寸6 s的要求。     

Improved photoelectrochemical hydrogen production over decorated titania with copper and nickel oxides by optimizing the photoanode and reaction characteristics

We optimized photocatalytic hydrogen production over TiO₂-based photocatalyst by varying the dopant (nickel and copper oxide), thin film active area, nature and concentration of sacrificial agents, and light intensity in a photoelectrochemical (PEC) cell/dye-sensitized solar cell (DSSC). Various characterization techniques have been used to investigate the structural, morphological, optical, and PEC behavior of single and codoped TiO₂. The TiO₂ decorated with both Cu and Ni oxides with active area of 1 cm² in a mixture of 5 vol % glycerol and 1 M KOH under light intensity of 100 mWcm^?2 produced the maximum hydrogen of 338.4 μmol cm^?2 for 2 h. The superior photocatalyst performance of this photocatalyst is attributed to its small crystallite size and large pore size, as confirmed by X-ray diffractometer, Transmission electron microscopy (TEM), and surface area of Brunauer-Emmet-Teller (S_BET). The absorption edges of this photocatalyst had the highest red shift compared with single doped and pure TiO₂ because of more indirect transitions of the photoexcited electrons, greater charge carrier separation, and lower recombination rate. The photoanode active area of 1 cm² with better photocatalytic performance correlated with the number of defects and grain boundaries. Glycerol shifted the conduction band of the photocatalyst to more negative flat potential compared with others. Increasing the concentration of glycerol further than 5 vol% saturated the photocatalyst active sites, increased photooxidation intermediates of glycerol, and reduced the hydrogen production. The light intensity had the maximum impact on the hydrogen production and could strongly control the number of charge carriers in both the PEC cell and the DSSC.     

六方相LaOF∶Er,Yb的上转换发光及温度传感特性

氟氧化物兼有氧化物优异的稳定性和氟化物的低声子能量,是上转换发光材料的一种热点基质材料,因而研究六方相LaOF∶Er,Yb的上转换发光性能及其温度特性具有重要意义。本文采用水热法制备了六方相LaOF∶Er,Yb荧光材料,通过X射线衍射(XRD)、扫描电镜(SEM)和荧光光谱对其结构和上转换荧光性能进行表征。实验结果表明,水热法120℃得到六方相LaF3,经800℃和1000℃退火后分别形成四方相LaOF和六方相LaOF。980 nm激发下,六方相LaOF∶Er,Yb中Yb3+与Er3+存在能量传递,通过双光子吸收产生绿光和红光的上转换荧光,并且Yb3+与Er3+的最佳浓度分别为3%和1%。最后研究了六方相LaOF∶Er,Yb在温度传感方面的应用,其在150~400 K温度范围的相对灵敏度和绝对灵敏度分别为0.037 K-1和0.0043 K-1。该材料具有优异的温度传感特性,对荧光温度传感器件的设计和应用具有指导意义。